Recent content by Precision

Outstanding! Congratulations on a beautiful deer

Here’s more pictures. Snow yesterday but mostly soaked in today. Finding does have to find a buck 🦌

Waiting for a break in the weather.

Good luck 🍀 with your hunting this year!

270 Winchester 122 HHT H4350 Ruger American 22" Factory barrel 1:10 + APS painkiller brake. FC 3x fired brass, Annealed, Full Length Redding Type S sized with 0.301" bushing, trim to 2.53" OAL Neck Tension 0.0035" CCI BR-2 primers Lee FCD 3/8T 0.050" off lands 3 shot Avg 100 yds 0.45 MOA Gr...

@still huntin , great updates, thank you much. I was just thinking about getting some starline brass for my 270, and found this thread searching "starline". I'm a tad bit envious of your velocity, I am getting ~3250 fps with 57 grains of H4350 running behind the 122HHT, 124HH, and 117HH in a 22...

Howdy @nv_breton : I also use Redding Type S FL sizing dies for my 7Rrem Mag and my 270. I see the same thing, if I neck size down with a smaller bushing size than the current neck OD, the HC (Case Base to case shoulder using comparator measurement) grows by 0.001 to 0.003". I understand this is...

Does it cost even less if the deer has already been dispatched??? :LOL:

Thanks, I saw the picture in the other thread you linked, but hadn't registered, as I was looking at the vials/box, or I am just a slow learner (potentially both).

Very cool solution premeasuring powder in vials of probable loads to shoot. I'm not quite getting the concept of the wilson bullet seater (does it run without a press?), but I think I could use the portable Lee press with my standard seating die? The wilson seater die instructions mention an...

Ahhh 💡moment here ... so that's how you guys load at the range. May need to add that to my wish list for Santa this year. I hate pulling pills, although it's ALWAYS windy where I go shooting.

I have butchered the deer, elk, and antelope, that I have been blessed to have harvested. I had the good fortune to be taught how to butcher by some experienced hunters with my first elk in 2017. I got started hunting *primarily* because of how much I enjoy the taste of game. I take as much care...

Good luck @LightTheTower, hope you have a fantastic elk hunt. I can 100% confirm the stair climber machine is the ticket to making the climbs somewhat less painful. The Selway region has lots of steep climbs, at least the parts I have hunted. Will be there in 2 weeks as well, counting down the...

Signed up for Graf & Sons updates on Peterson brass for this 270 project. In the meantime, working with FC brass from Riceman, and honing in on a 122HHT load recipe for this hunting season. Got back out this weekend with my newly installed painkiller brake and also swapped to a 50mm obj scope...