6mm Creedmoor 90HHT Help

[Mr6.5]

So I am going to take the 6mm back to the range Monday, I would love someone to check my loading data for sanity this time.
Previously I was using CFE223 and was WAY to hot and blew a primer. I have switched it up to the below:

Lapua Brass (Small primer)
CCI#450 Primers
Hammer 90gr HHT Bullet
COAL - 2.7250 (Light crimp with Lee Die)
VARGET Powder

My intended ladder -- (The moment I see primer signs or feel bolt lift pressure I will stop and back down .5)

START of ladder --
35.0gr
35.5gr
36.5gr
37gr
37.5gr
38gr
38.5gr

Can you guys verify for safety? I can find little to NO load info for 6mm Creed with the 90gr HHTs

THANK YOU!!!

 

[riceman]

Your ladder should be great, let's see where this goes before we go too high.
Pic shows 90gn bullet( Hornady online)

 

[Mr6.5]

Your ladder should be great, let's see where this goes before we go too high.
Pic shows 90gn bullet( Hornady online)

Thank you!

 

[riceman]

Mr6.5,
I don't have this cartridge, so im just looking at data. Yours and Hornady, question coal, large discrepancy 2.2750 vs 2.7250? Possible typo? Or you seated that deep? Just looking at #'s and verifying.

 

[Mr6.5]

Mr6.5,
I don't have this cartridge, so im just looking at data. Yours and Hornady, question coal, large discrepancy 2.2750 vs 2.7250? Possible typo? Or you seated that deep? Just looking at #'s and verifying.

TYPO! I fixed it, thanks for pointing that out.

 

[gltaylor]

Please include your twist rate, full range of powder charges tested & velocities.

Thanks for the data!